BrightHeadlights-Hid.com
  • JW Speaker LED Headlights
  • Home
  • Fire Apparatus & EMS - Seal Beam
  • Large Trucks
  • Comparison Xenon HID Headlights Versus Led
  • After Market Xenon Kits
  • What Fits my Car/Truck
  • FAQ's
  • Contact Us
  • See Our Old Web Site for Additional Details
  • Parts List
  • Installation
  • Schematic Diagram Circuit
  • Schematic Diagram Circuit
                             Installation 
No cutting Required to new bucket above
Not needed  Remove Chrome rings around bulbs then  remove Seal Beam lamps  then Cut Aluminum Nest to a larger hole .
PictureNest Cut Out









Picture







           Nest Cut out

Picture






High Beam  High/Low Projector 

Picture

Second :   Cut the Bucket (behind seal beams) Below Low Beam  both sides to allow projector to fit
Picture






Bucket Cut Out

Picture






Bucket Cut Out

Picture






Bucket Cut Out

Picture






Bulb Installed

                      NEW EIKO Ballast & B2B Cable                                                                                                                     A Cable power  and flapper
                                   Part# 9122014                                               D1S Xenon Bulb EIKO for both
​                                                                                                                  Ballast, Bulb# 312010                                                                                                   
​Denzo Ballast  replaced by                                                       Old  A-Cable Power Cable for Denzo Ballast         C-Cable Bulb to Ballast for Denzo  obsolete            ​New Silver EIKO Ballast                                                                                                                                                                                                                                                                           

                                                               Wiring 

Connect: A - Power Cable to OEM Original Bulb Plug , Then into Ballast and into High Beam Flapper Plug  on Low Beam Housing ,
Connect: the new LED Bulb plug adapter in to OEM Plug 
Wig Wag  feature must be disabled and Reduced Voltage DRL Daytime Running Lights must be Disabled or use relay B cable kit to attach to 12 v source  ,     Ballast can't handle reduced voltage or pulsating voltage .


Picture
Old A-Power Cable to Adapter
to New EIKO Ballast

Picture









Ballast,  D1S, Projector Assembly



Picture
Complete Circuit of Xenon

                      RELAY for B-cable to supply full 12v to ballast if needed

Picture
Picture
Picture
Picture
Newest Relay  S11-1A-C1-12  30A /12VDC
Original 2 Relay HLS-4121-DC-12V  30A /12VDC
Original Relay 804-1A-C1 12VDC
30a /12VDC
Pin view same on all versions

                                      Schematics A , A1 , B , C

Picture
Picture

Picture

Picture
Picture
Bruce Chandler
www.BrightHeadlights.com
377 Rubin Center Dr. Suite 115
Ft. Mill,  SC. 29708-7257
704-523-3548 office
704-564-3383  cell
704-525-0221   fax
Bruce@Datasyst.net
Since 2001
Proudly powered by Weebly
✕